Cant get air out of coolant!

Having this problem with both my 98 dc2 and 98 ek (y8)... Followed the service manuals for burping coolant, and even after an hour of burping (squeezing hoses, revving up, heater core open, etc...) I still cannot manage to get the air out (still bubbling). Cant find any leaks

Did a chemical block test on both cars, both passed... so there's no way the air can be a blown head gasket..

What are some possible reasons I cant get all the damn air out of both cars?

Edit: I have repeated this process for several days on the dc2 and driven over a hundred miles

Posted Sep 2, 2019, 6:54 PM UTC

116
mount_curve•

Try bleeder nipple(s?)

Idk I always had problems bleeding those old Honda single cams, felt like sometimes it would start idling funny a week later and belch out another bubble...no idea where that shit hides in the system.

1
Low_Key_SlapsOP•

There is no bleeder screw on either my ek or dc2. I'm following the proceedure specified by the manufacure. It shouldn't be this difficult if the car is working correctly right?

1
mount_curve•

Shit, forgot about that. Thermostat is for sure opening up? Upper hose getting hot?

1
Low_Key_SlapsOP•

Yeah left it running long enough for the fans to turn of several times. Both upper and lower hoses getting hot, temp gauge seems to stay stable within the normal range. Wierd that I'm having the same issue with both my teggy and civic..

1
thetrueERIC•

As you're filling have the temp sensor on the thermostat housing removed. While filling the coolant will push out air through this opening. Try this, and if not head gasket time.

1
thebadmechanic•

Go borrow a vacuum coolant refiller.

1
Low_Key_SlapsOP•

Problem is that you shouldn't need one right? If nothing is wrong with the cooling system, and im following the procedure in the service manual specified by the manufacture, then I shouldn't need to use a vacuum tool.

1
thebadmechanic•

The cleanliness of theory is no match for the mess of reality.

2
Low_Key_SlapsOP•

True but I still feel like the manufacture should know how to properly bleed air from the system they themselves engineered, or at least give a better proceedure to follow in the manual

1
thebadmechanic•

Agreed. Is the system overheating, where are you seeing air? Is it consuming coolant?

1
kyden•

Run it with the front end in the air?

1