What is this structural component that holds the ceiling joist and hanging beam together?
Hiyo! Long time lurker, first time poster.
I just bought a 1922 craftsman home in SoCal and tore out the acoustic tile ceiling that was hiding some huge plaster cracks due do what I think was the weight of all of that, the house settling, and just general age.
I'm in the process of fixing my sagging ceiling with my dad (who is a contractor) but I'd like to know what this component is:
Also, any armchair or pro advice for replacing ceiling joists is much appreciated. Thank you. Really love this community. Hope I am able to contribute more.
Posted Oct 27, 2019, 5:08 AM UTC
It's a little difficult to tell what's going on from this angle. They appear to be tied to that doubled 2x beam (running parallel to your ceiling joists), is that correct? If so, I'd imagine that they serve to just keep the ceiling joist from sagging. Since it's an old house, it's likely that the ceiling joists are overspanned by modern codes. Not necessarily a big deal, that's pretty common with any old house. Also....you want to actually tear out all the ceiling joists? WHY? That would be a huge pain in the ass, and really messy and destructive, for no apparent reason as far as i can tell. If you really want to to do that, make REAL sure that your ceiling joists aren't also doubling as rafter ties, which is common. Unless you're interested in having a sagging roof too. If you want to install a new ceiling and just straighten out some of the weirdness of the old ceiling joists, it'd be a lot easier to install some 1x3 strapping on your joists, perpendicular to the direction they run, 16" oc spacing. google some images of "drywall strapping" or "ceiling strapping" and you'll see what I mean.
Hi, thanks for the response. It is definitely hard to get a good angle, but here's another one:
https://imgur.com/a/rkq8gxt
You can't see in the picture but the bow is almost the size of the beam. It's like 3" off. Another option we were thinking of was putting sisters on the ceiling beams and just cutting the originals to the sisters.
Here's my question: what is up that double 2x beam that is above and perpendicular to your joists? Are they tied to that beam with those little scraps in question?
Yes. The 2x beam is perpendicular and holding the ceiling joists with those scraps. The 2x beam is straighter, but because the weight of the ceiling was so heavy, the scraps ended up being pulled down along with the ceiling joists causing the sag. I'm not there today, but I kind of expect the nails to have dragged down/out the side of the beam as well.
I think you can potentially avoid having to tear out your ceiling joists if you jack up the joists along the centerline, where the beam is above. Push the joists up so that they're touching that double 2x beam (I'm assuming they aren't currently, due to the sag), and then re-fasten them to the beam. Hurricane ties might do the job, or some other method using structural screws/lumber would work too. This is assuming that the joists will still flex, of course. In this scenario, I believe you could get most of the sag out of those joists, and then you can still do 1x3 perpendicular strapping in order to smooth out any remaining unevenness.