Kailh Hot Swap Popped Off
Looking for some help with this. The hot swap pin popped off and was wondering if this is salvageable. Looking for any insights and thank you a head of time! https://imgur.com/a/3VoEAZb
Posted Nov 25, 2019, 4:55 PM UTC
Looking for some help with this. The hot swap pin popped off and was wondering if this is salvageable. Looking for any insights and thank you a head of time! https://imgur.com/a/3VoEAZb
Posted Nov 25, 2019, 4:55 PM UTC
I know that PCB and that case, and it is an extremely common issue with the boards from the groupbuy.
Where are you located? r/mechmarket has a few guys who can fix that if (like me) you have neither the skills nor the equipment to do it yourself.
I am in Salt Lake. It does seem just outside my skill set but im all for learning. I just hate to screw it up as this is my wifes XMas gift.
The pcb build quality does seem a little sub par but other than that i really like this board. The weight and wood are great.
Yeah, it felt a bit less than premium. But where else are you going to find a wood case like that?
If there isn't someone local to you, I can recommend u/razgrizacez's services. He's already fixed mine, might be able to get yours turned around pretty quick?
Thanks man ill take a look!
Thanks to u/wlpaul4 for the mention. This is a common issue on kailh sockets, and isn't very hard to fix with a soldering iron, and a jumper wire. I can fix it for you but the cost/time for shipping seems a little excessive so you can look at u/shmarcia's services since he's closer to you in Utah. Good luck with everything!
Yup, happy to help! Should be doable as long as the wiring isn't totally ass on the pcb
From what I remember the right pad was the diode to the right but for some reason the left pad was somewhere else. might have to play with the second jumper wire, thats what I ended up doing till I got one that worked.
Hi, it appears you may be new to this subreddit! Please check out the wiki for general information about mechanical keyboards and consider posting questions in the daily sticky post at the top of the page for any smaller questions.
I am a bot, and this action was performed automatically. Please contact the moderators of this subreddit if you have any questions or concerns.
Both pads are lifted. You'll want to glue the socket down and then wire to the via directly above the left pad for that pad (you'll need to scrape it a bit, or you can follow it to where it connects to of course), and to the left side of ND108 for the right pad.
This commonly happens when you don't support the back of the socket when putting in a switch. Unfortunately, it's difficult to fix; the only real way to correct it is to tap into the trace for each of the solder pads and use a small amount of glue to attach the socket to the PCB. If you're not sure how to do that, there are YouTube tutorials and some skilled builders who can do it for a fee.