Any help appreciated!

Posted Dec 1, 2019, 12:16 AM UTC

Posted Dec 1, 2019, 12:16 AM UTC
From what I can see initially the space bar switch has a melted plastic center and no solder on one pad. The other pad for the space bar switch looks fine. I leave it to others who are more knowledgeable though.
Yeh I tried adding solder to it, but it doesn’t adhere to the board, it just sticks to the iron and doesn’t leave it
That area is dirty as hell. You need to desolder the switch , clean those dirty areas with a q-tip and maybe isopropyl alcohol. Replace the switch completely and resolder.
I already tried that with 3 other switches, the solder doesn’t stick to the left peg’s pad at all
I think that's because there is no pad left. It appears to be gone. You can probably use a jumper to make the switch work, but that's above my pay grade. Hopefully someone else can chime in and tell you where you can jump from.
Also you probably can’t save that switch so I’d just replace it with a new one.
In general, follow the traces from each of the damaged pad to see what it connected to, and then you can add your jumper wires to restore those connections.
Also look at R79, R6, and R82, it looks like 1-3 resistors were knocked off the board.
Where would I jumper two exactly? Sorry im a little new to this
Could u make something of a diagram like this?
That’s another users issue, just wondering how to wire it in terms of the space bar
I can only see some of the traces since there isn’t a picture of the top side of the board, so I’m extrapolating a little bit here. Also, when I say “right pin” I mean the lower pin in the picture since it is rotated.
It looks like the right pin of the space bar switch may connect to the bottom of the extra diode to the right of the B switch. The left pin of the space bar may connect to the silver-colored test point immediately to the left of it.
For the escape key, it looks like the right pin connects to the extra diode one switch position below it. I cannot tell where the left pin connects, you will have to look at the traces on the board.