[QUESTION] Are the E strings supposed to be evenly spaced from the edge of the fretboard?

QUESTION

I apologize for not taking a picture, but I went to look at Player Series Tele's at my local shop today and both of them seemed like the neck was sitting weird in the pocket where it connects to the body. What made it obvious was that the space between the edge of the fretboard and the low E string was nearly double that of the space between the fretboard edge and the high E string when looking down the neck from the base to the headstock. The shop salesmen didn't seem to notice it and were more concerned about bowing. My Strat has perfect spacing when I look at the same spots.

Is this normal? Something to be concerned about? Easily fixed? Thanks in advance for any replies!

Posted Jan 7, 2020, 1:44 AM UTC

112
weekend-guitarist•

Mine are evenly spaced on all guitars. However with a bolt on neck you can skew to one side or the other as desired.

3
EntryLeveledOP•

I'm guessing this doesn't effect playability?

1
SirCarrington•

No, it certainly can affect playability. Sometimes a string is close enough to the edge that it can easily slip off when fretted.

2
EntryLeveledOP•

That makes sense.

1
MojoMonsterGibson/Ibanez/Carvin/Fender/Egnater/Peavey•

I've always set mine up with the low E string closer to the edge and the high e string further. My thinking is that I bend the low E in towards the center but I vibrato the high e string, so I want a little more room to do this.

2
EntryLeveledOP•

Interesting. So you do it on purpose!

1
MojoMonsterGibson/Ibanez/Carvin/Fender/Egnater/Peavey•

Yes.

If you have a bolt neck you can make this adjustment by tilting the neck just a tiny bit, one way or the other.

Now if you're talking about the nut slot spacing, that's usually to account for the width of the strings and making sure the edges of the strings are equidistant.

2
EntryLeveledOP•

Great, thank you. It does seem to be a small enough difference that you can just loosen the bolts a little and slightly nudge it the other way.

2
mikeyj198•

was it used?

I bought a godin with an aftermarket bridge and whoever installed it did a poor job, placed a bit too close to the treble side.

1
EntryLeveledOP•

Both brand new. The one actually had more room on the high E side while the other had more room on the low E.

1
ruler_gurl•

It's not uncommon with cheaper bolt on neck guitars. Olden days it might be a messed up bridge routing. But since so much of it is computer controlled that's less likely now. More likely that the neck is just bolted in a little crooked. Given the length of the neck, just a degree off center would skew the strings sideways where they meet the body. It can happen in assembly or transit. Loosen the strings, loosen the neck screws half a turn, bump it over, tighten, and retune. Repeat if necessary.

Or, it could be a fubar bridge routing.

1
EntryLeveledOP•

Okay, thanks for the tips!

1