Oil still showing up where transmission meets engine after rear main seal replacement. What do I do next? 2003 Mazda Miata

I saw oil on the transmission and assumed that the rear main seal was bad, so I pulled the transmission off and replaced the seal and did a full clutch replacement while I was in there. I put it back together and it still leaks. Should I reseal the oil pan now?

I did notice that some sealant between the engine and oil pan was coming off, but I wasn't sure it was a problem. I did take a photo of the back of the engine before I cleaned off the oil, but it isn't really clear whether the oil was coming from the main seal or the oil pan seal.

Posted Jan 19, 2020, 12:55 AM UTC

13
sparkybc•

Looks like the pan.....

1

Should have put in some uv dye and run the engine. The leaks glow under a blacklight. Hard to tell from this pic, quality not great. Not leaking from trans input seal?

1
boothinatorOP•

Yeah, that would have been smart. And using a better camera would have been good. Maybe I should put in the UV dye anyway. I don't see a leak from anywhere else behind the engine, but it's possible that I missed it. Apparently oil pan leaks are quite rare on Miatas, so it's likely to be something else.

No, I didn't see any leaks from the input seal, just a bit of clutch dust. Besides, the trans fluid is red and the leak is black.

Do you think I could fit an inspection camera between the engine and flywheel if I remove the starter?

1