im new to 3d printing. i need some advice

hello im practicing with some teeth stls

the gray one is made by a friend on an ASIGA printer and the black one is made by me on the anycubicphoton printer but mine looks "compressed" and idk why?

also can you guys recommend me some settings or if you use some other slicing soft other then the one the printer comes with

p.s sry for my bad english

https://preview.redd.it/9wn8fnpwsbc41.jpg?width=3096&format=pjpg&auto=webp&s=08fdc8618f696be6b406b621c53280e82f08888c

Posted Jan 22, 2020, 12:55 PM UTC

04
HeadsDesignZ•

I posted my settings a little while back, so you can check my profile for those.

I use Chitubox for doing supports and slicing. I haven't even installed the Anycubic slicer software.

2
AgentOrcish•

Gotta angle them on the build plate before you slice them.

Try this method of orienting and supporting.

https://youtu.be/S4KRazqrMjE

2
LeanRimeOP•

i guess is the angle i angled my model flat

1
pangolinest•

I see no layer or pixel lines on your friend's print. I looked up ASIGA and they appear to be in a whole different price range then Anycubic. I might assume your friend owns a true SLA printer while Photon is a DLP printer. They are similar yet quite different technologies with SLA being better and far more expensive then DLP. When you print sudden large flat areas on a DLP printer they layers tend to sag or even peel from one another due to suction forces when your print unsticks from the FEP. To avoid sagging and get a slightly better details you have to experiement with model angle. Also you might try to slice your model in the native Photon slicer to avoid any potential weird behavior.

2