"Overclocking" RAM causing blue screen
[removed]
Posted Jan 27, 2020, 3:04 PM UTC · edited
[removed]
Posted Jan 27, 2020, 3:04 PM UTC · edited
is the ram actually 3000mhz? or is it 2666 memory that you are trying to run 3000? i can't count the number of residents of this reddit that buy cheap ram, and then try to run it outside its rated spec thinking its going to work flawlessly because some dude got lucky running his XXXX speed two or three speeds faster.
It's rated at 3000, and I had it running at 3000 just fine before I upgraded my mobo and GPU.
sounds like you bought a motherboard without checking the ram compatibility list, and as such it wont run said speed because it isn't supported on that motherboard.
also note Ryzen HATES uneven numbers for ram. So if you are trying to set say cl15, it will actually automatically drop to cl14, which can cause instability
I have same GPU nvr had a freeze or crash or anything at all using dual monitor aswell updated MB bios to latest put my mem at 3000 mhz and all stable 2 months now using a 1600 stock and gpu stock
These gpu like all on stock clock and should be very fine at least for me so answer is yes ram oc on these gpu can cause and probably cpu oc aswell very sensitive arch for sure.
Select the xmp profile in your motherboard bios
No profile = no overclock
Being able to run ram at the rated speed is dependand on the quality of the memory controller on your CPU. Some chips have a good memory controller, some not so good. If you have cheaper ram (i.e not Samsung B-die) it's harder to run at rated speeds - especially on the orignal Ryzen (1000 series) and Ryzen+ (2000 series).
The fix is to try upping the ram voltage and see if it irons out the instability (wouldn't go over 1.45v personally for daily use) OR use Ryzen Dram Calculator to figure out the optimal timings for your ram kit - though this is a bit more of expereinced users. Alternativly just stick the XMP/DOCP profile on and then dial back the speed until stable (i.e run your 3000mhz at say 2666mhz like you've been doing.)
If it helps, my 2700X won't run my kit of 3200Mhz B-die ram at anything faster than 3000Mhz - and this is even after tuning it with Ryzen Dram Calc or I get BSOD's like you.
Thanks for the reply. I've updated my post with a bit more information. What confuses me is that I was running this RAM at 3000 with no issues at all until I upgraded my mobo and GPU.
Well bios can make a difference, but it's odd you would lose performance.
It's very likely not your graphics card, but your CPU. How did you "overclock" your RAM?
I just changed the speed in my BiOS. My RAM was running just fine at the correct speed before I changed my motherboard and GPU. FWIW, I upgraded to the exact same motherboard (MSI B450 Gaming Plus), but I just went from a Mini to a normal sized board.
That might not be enough. Try using Ryzen DRAM Calculator to get the right timings for your RAM/CPU.
I will give this a shot when I get home from work. Thank you.