Source
denhalOP•

I have an Anet A8 with the latest marlin firmware and a Riko sn04-r auto level sensor.

I've leveled the bed as much as I can and when I print these squares the left side always comes out terrible. In this image it printed the squares in the order front left, then center, then back right, then back left, then front right all using the same settings.

Any ideas what I can do to fix?

1
d3lap•

Your Z axis might be out of alignment. Use a ruler or calipers preferably and measure the distance on either size of the bed to see if the vertical distance is the same.

2
denhalOP•

https://www.thingiverse.com/thing:2481481

I printed 2 of these and I use them to check.

1
d3lap•

Oh Damn those are handy. I'm sorry, I do not know what else to suggest. I'm struggling with a skipping extruder motor on my Anet A8.

Could your bed be warped?

1
bylXa•

After heat , bed will deform , and probably will deform from side which springs are tightened more.Anet has a very poor suspension for bed , which is also heated

Just a little unscrew nuts(bolt) to lift bed from problem side.

1
denhalOP•

I'll try that.

1
GloryToMotherRussiaF410, Industrial Product Dev•

Autolevel then look at the console, if that's how yours works. Should give you heights for each corner and you can adjust manually from there

1