Need help to identify a burned component

Need help to identify a burned component

Posted Mar 31, 2020, 3:11 PM UTC

05
epijdemic•

looks like a voltage regulator but can be just anything in that package

3
pasterpOP•

I was able to identify a few things.

The top connection on the right is +5V and the bottom left is GND.

The top connection on the left goes to the input of the IC for battery charging. The line to EN2 have a 145ohm resistor on it.

Current Limit Configuration Inputs. Use EN1 and EN2 control the maximum input current and enable USB compliance. See Table 1 for the description of the operation states. EN1 and EN2 are internally pulled down with ≉285 kΩ. Do not leave EN1 or EN2 unconnected to ensure proper operation

The table mentionned: https://i.imgur.com/74cuOYS.png

1
epijdemic•

U1 & U3 are the same package. check for U2 and maxbe they are all the same. with the markings you might be able to ID the fries chip

2
_m0xya_•

Try to identify the cause of the failure. It may be the result of another fault.

2
pasterpOP•

I'm trying to repair a Kobo Touch but it is not booting.A led reacts when I power it over USB but I don't think it can charge the battery.I noticed that burned component (red square on the pic) on the card that can't identify but it looks like the only damage on it so I want to investigate it.

Battery is 3.7V Li-ion, it currently deliver 2.5V.
Closest IC (U2 on the board) is a li-ion usb charger (http://www.ti.com/lit/ds/symlink/bq24074.pdf)

1