r/TheeHive•
pinoline

decided to give my hotplate a break..

decided to give my hotplate a break..

Posted Apr 1, 2020, 5:16 PM UTC

4814
pinolineOP•

fun fact: electrical relays are more robust, and can handle more cycles than mechanical relays.

switched out to the Mypin PID and SSR, I use for the SFE . That heating pad was used to heat a 1L Swagelok sample cylinder, after filling it with CO2. SS thermocouple measures the temp. Just recrystallizing dmt here, with EtOAc and hexane.

This particular heating setup could be employed with a plain-jane magnetic stirrer

10
sircow22•

The boiling flask hanging off the ring stand-rod gives me an exceptional amount of anxiety for no real reason

4
pinolineOP•

haha, I hear ya. a part of me dies inside everytime glassware is broken. I rinse RBFs with methanol, and let them dry on too of the stand

2
xBROKEx•

is that a nitrous bottle warmer lol, if not they are made out of the same stuff

3
pinolineOP•

honestly, Idk. I do use it to heat a stainless steel vessel, to get CO2 into a critical state. It's a Watlow heating pad, got it on ebay for about $65

I'd imagine it's similar to what you're describing. it is fiberglass

2
Psychonaut-zeta•

Ah the good ol crystal drain opener 🙂

2
pinolineOP•

Roebic ftw

2
TheBratOG•

Fuuuuck i want a hotplate stirrer.

1
the_other_maker•

What wattage?

1
pinolineOP•

the heating mat? 250

2
the_other_maker•

Thank you sir, we used similar for some stainless test baths during my working career.

I could not remember details. This was a decade ago.

3
Mr_bovinejony•

What type of variac is that? Been looking for a cheap one since I have two hot plates thatre dead and only useful for stirring

1
pinolineOP•

it's a bit different than a Variac, which uses a mechanical relay..it's a Mypin TA7, PID controller, with 20A digital relay.

1