Completed build - first AR build and first AR10, can't wait to try it out!

Posted Apr 10, 2020, 11:58 PM UTC

Posted Apr 10, 2020, 11:58 PM UTC
Thank you for including the cost! I'm about to start a build myself but very, very slowly (one part at a time so the wife doesn't notice the cost and complain). Is that a typical cost I should expect or were you splurging a bit?
I definitely splurged on a few things. You could get a few parts cheaper, like going with a milspec trigger along with the standard A2 grip, etc. and a cheaper stock, a cheaper charging handle, and cheaper upper/handguard. I built it with parts I'd otherwise want to upgrade to if I were to buy an off-the-shelf rifle and was targeting $2k w/ optic. I've seen builds at ~$1,000 w/ optic, though - cheaper optic, obviously and not a $200 mount, no bipod, etc.
This sub is a good resource if you want to search builds to find a budget-oriented build. I was aiming for a good value gun for relatively long-range and not the cheapest, but plenty of builds on the cheaper end. You'll get much more gun for your money building it than buying it, but you can get a pre-built M&P10 for ~$900. With deals I'm sure you could build one for $700 or so, maybe less, but not quite as crazy cheap as AR15s.
Thanks for the insight! I already have a crazy cheap AR15 and this one I wanted to be the actual good one, just wasn't sure we're on the price scale it would fall.
Nice. Now you’re part of the
#First AR build was an AR10 Club
I’m also a member.
The sun shade really sets it off nice
How was it for a first build? I'm thinking about doing the same, once I can actually go out and shoot again.
Cakewalk, aside from my stripping the 4-40 set screw for the takedown detent (it's friggin tiny and you have to be pressing against a spring while doing it). The rest was very easy to figure out with a few videos, most of the small springs and such won't go in the wrong spot (safety spring is slightly larger and much stiffer than takedown spring, etc.) The hardest bit is installing the roll pin on the gas block, unless ya have 3 hands to hold the pin, punch, and hammer or are smart and bought a roll pin starter punch.
That's a good lookin' rifle.
That scope is a DONK
Nice pretty close to mine but more FDE furniture. and atlas bipod.
Build parts list copied below, from this post
[deleted]