r/pools•
thingker

Pentair temp sensor 4-wire vs. 2-wire

Posted Apr 16, 2020, 9:27 PM UTC · edited

412
ParkieDude•
2
thingkerOP•

I added some photos I have. Does that help or I can go back to it and get models/serials if needed

1
ParkieDude•

You need to get someone out there to help you.

The four-wire J20 (is a communications port).

You have a very nice and clear picture inside that front cover of where the wires should be connected.

Could you step back and take a photo of that wiring diagram?

Ditto to step back and take a larger photo showing J20 and what those wires connect to?

1
Schteve0•

I replaced one recently and had no problem buying a 2 wire sensor on Amazon.

1
thingkerOP•

Did you replace a 4-wire with that new 2-wire?

1
[deleted]•

u/tehSpaz is your friend...

1
TehSpaz•

Is this a beige box easytouch or a black box? I'm pretty sure you have you're wires mixed up anyways -- what you described is the 4 wire connection for the com devices. The temp sensors each use 2 connections on a 6 con block next to the 2con for low voltage heater.

1
thingkerOP•

I added some photos. The wire block shows the 4 colors coming from the temp sensor (shown in another photo). From what I've seen so far I only need a new temp sensor that only has red/black and it should be fine?

1
TehSpaz•

You got the wires mixed up tracing them. That's not your temp sensor wires. the only two things on that terminal are your VS pump (thicker yellow and green with a black wire with metal shielding inside) and an interface of some sort (screenlogic? Wireless remote? Wall control?).

Your temp sensor is a beige wire with red/black that goes to a 6-terminal block with two wires using 4 terminals each (unless you have a solar heater, then all 6 will be used).

2
thingkerOP•

Geesh, you know your stuff. I did mis-trace the wire. I didn't want to pull out the mess of wires coiled in the chase, but I should have! I also do have a wireless remote.

The temp sensor is just a 2-wire and it goes to the 6-terminal block. It's for the solar. I've ordered a new temp sensor and will swap it out ASAP

Thanks a ton. I appreciate your help!

1
TehSpaz•

That's your water temp sensor in the pic. Your solar sensor would be up on the roof exposed to the same air and sun as the solar panels.

1