r/ElegooMars•
Natemiester

Weird edges and layer skip in print

Troubleshooting

I'm attempting to print WalRit's Hollow Knight model, and it mostly turned out ok. Cloak failed, due to insufficient support, but the base and sword have some strange issues I'd like help with. Album is here.

The base is fine, except for one corner which has strange bulges and flattening

The sword, meanwhile, had a very bent handle, and a strange notch, where it looks like it skipped several layers.

Resin is a 75/25 mix of Elegoo gray/ Siraya tech tenacious, 10 bottom layers, cured for 65 seconds, 8 second layers otherwise 0.05mm layer height

Any assistance you guys can provide would be greatly appreciated!

Posted Apr 30, 2020, 12:26 AM UTC

10
Loading comments…