Keeping brass from spinning when removing primer pocket crimp

I have the Lyman primer pocket crimp remover which is basically a reamer that cuts out the crimp. It works well enough. I also just received an FA Platinum case prep station. The issue is that if I put the primer pocket reamer bit on the FA tool, I can't keep the brass from spinning. Does anyone have suggestions for the best way to hang on to the brass and still hold it fairly straight so the primer pocket doesn't get loose/deformed?

Posted Apr 30, 2020, 4:20 AM UTC

10
Mr_Perfect20•

I wear an old batting glove when I trim or remove crimps. When I'm just cutting the crimp, I always turn the brass opposite the direction of the cutter. It just goes faster that way.

Never had a problem with damaging the pockets, and the only 223 brass I've ever used is scrub range pickup.

3
jewjewbee_1234.223, .308, 7mm-08, 7mm rem, 30-06, 9mm, .45acp•

Hold on tight

2
KorbenPhallus•

Any type of rubberized gloves will help tremendously, even just latex or nitrile disposable. In fact, if you use gloves, use ones that are weak. That way if something goes wrong they will rip apart instead of your hands.

I also modified a pair of narrow pliers for my current 4k+ batch of .223. I found a dremel grinding bit about the diameter of the rim of a 223 case, and carefully created a "C" shaped cutout on both sides of the pliers. I wrapped that in tape, and grab the head of each case with that. It works great, and totally saves/protects my hands

2
[deleted]•

[deleted]

1
Dht808•

Try holding the brass in a piece of rubber or silicone. The Inner tube of a bicycle tire would work, cut and slip it over your fingers.

1
fumblesvp•

You can build a case holder from Lee parts and a interchangeable head screwdriver. You need one lock stud and whatever caliber gauge holder you are reloading. This lets you grip the screwdriver instead of the case making it much easier on your hands. Links below to examples:

https://www.amazon.com/LEE-PRECISION-223-Gauge-Holder/dp/B000LC2348

https://www.amazon.com/LEE-PRECISION-Cutter-Lock-Stud/dp/B000NOQIOU/ref=psdc_4200921_t1_B000LC2348

https://www.amazon.com/Lenox-Tools-23931-Multi-Tool-Driver/dp/B000LG89SI/ref=sr_1_4?dchild=1&keywords=multi%2Bscrewdriver&qid=1588262130&s=hi&sr=1-4&th=1

1
SlantedBlueOP•

But the primer pocket is in the case head... how do you ream the primer pocket with the Lee tool attached?

1
fumblesvp•

I'm an idiot. I read the post and then replied as if you were trimming cases. Definitely won't work. Sorry for my stupidity.

1