r/ft86•
Napagogue

How do you guys bring your bikes with you?

Do you have seasuckers, bike racks or how do you do it? I've been looking in to this and can't find a good solution. Not sure whether I trust people enough to let a seasucker sit on the car most of the time without getting stolen and I also don't want to be installing and removing it too much

Posted May 11, 2020, 11:26 AM UTC

620
AzonIc1981•

I use a roof rack bike rack, but across the back of the car on two rods I had made up that screw into the tow hooks. https://m.imgur.com/a/ZFnYZ

5
sudo_reddit•

That's fantastic. What are the rods made of and what thread is the tow hook?

3
AzonIc1981•

Mine were made out of stainless steel. The thread pitch is M16 x 1.5 I believe. I gave the engineering firm my tow hook and they measured all that out to ensure that the fit

3
NapagogueOP•

Wow I love that! How stable is it when driving?

2
AzonIc1981•

Very, no issues.

3
Sabrewings•

I did a very similar thing. I think I saw a post on the forums a long time ago and copied the design.

​

I made mine from aluminum so they are nice and light.

2
Murdathon3000•

Damn, you're fucking genius sir lol

1
AzonIc1981•

I can’t take credit unfortunately as many others have done the same before me!

1
NapagogueOP•

I'm going for this solution! Do you know what type bolts you used? Would be of huge help

1
AzonIc1981•

These were custom made rods by a machine shop.. cost me about $AU200 for both from memory, and $100 for the bike rack second hand

2
NapagogueOP•

Came back here to tell you I went to copy your setup and it's perfect. Luckily I found a pair of long perfectly fitting bolts that I welded into a thick metal pipe. Been using it for over a week now and couldn't be happier. Thanks a lot for the inspiration

2
myfame808•

My bike actually folds in half and I can stuff it in the trunk with the back seats down. It's the Montague Paratrooper for anyone interested.

2
Jaredtri589•

I was very reluctant to get a seasucker but now that I have one I love it. They are not cheap, but they are really good quality. It is pretty scetchy the first time you have it on the car but, I've used it to drive back and forth from Houston and San Antonio half a dozen times and it's held up well.

2
NapagogueOP•

So you're not worried they might fall off anymore? How's the paint holding up?

2
Jaredtri589•

Its always in the back of my mind but after checking hourly to see if it retained full suction and it did it really put my mind at ease. The paint is totally fine as I put the front part of the rack actually on the rear glass and the rear wheel holder right in front of my rear spoiler. I gotta say I'm pretty impressed with the rack and it's probably the best solution I've seen that allows you to take it on and off quickly.

2
admjwt•
2
glowdemon1•

I remove the boot liner and the styrofoam below it and put the bike inside with my front wheel off. Handlebars get covered with a pillow case, I place the handlebars behind the passenger seat and push it neatly against the handlebars so the bike does not move.

1
Tdotbrap•

Take front wheel off, seat post off, fold rear seats down, in it goes.

1
Mooncaller3•

Usually use the pass through and pop a front wheel off if I must.

1
panda_brz•

I have a road bike. Recline the passenger seat all the way back and take the front wheel off the bike and maneuver the bike into the backseat and passenger side. Not safe but it get the job done.

1