Questions on short splicing

Hello! I’m beginning to learn how to short splice rope, but I have a couple quest that I could not find any answers for.

First, how do I finish the six ends of the short splice? I’ve seen them whipped and un-whipped, cut long or cut short, knotted and un-knotted, but which of these is the best?

Second, I’ve heard of tapering the short splice to make the change in diameter less abrupt, but I don’t know how to do that. Ashley mentions several methods, but which one is the best of these?

Posted May 17, 2020, 12:45 AM UTC

52
mr_nobody8913•

How you end a short splice really depends on what you want the splice to do. Does it have to run though any opstacle or is it just going to hang in the center of a line? If there's no concerns about the splice snagging on anything, leaving the ends be would be enough. In natural fiber rope, they will eventually wear, or after the rope has seen a bit of use and has worked in, you can shave the ends closer.

Since you are referencing the ABoK, take a look at #2641

In it, he is saying that strength-wise just a standard short splice will do just fine, and notes that the varieties tend to stem from isolated attempts to give the splice a softer edge (or taper) since sailing vessels tend to need the majority of their lines to pass smothly over or through obstacles. ABoK# 2638 is highlighting one captain's attempt to give his short splice more longsplice qualities with cutting the yarns, but then whipping around them to try to keep that strength.

ABok# 2640 involves whipping because, as a splice for a cargo sling. Riggers don't mess around when it comes to safety. The splice should hold, but the whippings will make sure of that.

Knotting with the ends or covering the ends with knots acheive the same as whipping, but add a decorative flair. Bonus if you leave the ends long enough to do a 3 strand buttton knot. Decorative and directly anchors the strands.

"Every ship has its own long splice and every sailopr has his own short one."

For me, I tend to be working with natural fibers like hemp or sisal, so I tuck my splices twice full, then cut the yarns to two thirds thick for my next tuck, then one third thick for the final tuck.

To see the actual practice of it, check out how this rope grommet is finished off. The splicing starts happening about 5:30

3

Hi. I'm far from an expert but I've done quite a lot of splicing today and a fair bit in the past. It really depends on what type of rope you're using. With a synthetic, you can heat seal the ends (sadly, I no longer have access to a hot-knife but close cropping and a lighter look fine to me). For natural fibres, I've always whipped the end of the splice (after cutting close again) as I don't know any other way to stop the whiskers and I really don't like how they look.

I'm not familiar with the knots you mentioned, but that could be a decorative finish? You'd still have to deal with the strands, though, unless you whip them individually (bear in mind, I'm talking out of my ass here).

As far as adding a long splice to a short splice, I don't really see the point. If you wanted it slim, then the long splice should probably have been your starting point, adding it later won't disguise the short splice or hide your ends.

Good luck, and I'd love to see what you end up with!

Edit:

I re-read what you wrote and now see what you mean about tapering! Yes, you could do, say 4 tucks with one strand, 5 with another, and 6 with your third. I've often found that this looks a little uneven (strands end up in a line on one side of the rope, and probably not the same side at each end!) but you could always have a go and undo the last trucks if you don't like it.

2