r/Ubiquiti•
Watada

Unusual ER-X "firewalling" or "routing"

Question

Heyo. This is a weird one.

I have an ER-X and recently configured it to bypass my AT&T fiber internet router using 802.1x authentication through wpasupplicant. The guide I followed is linked at the end. I wasn't able to follow the directions exactly and used a different version of wpasupplicant linked in the comments which is compatible with the ER-X, mipsel. The version in the guide is 2.26-21 (mips) while the one I installed is 2.24-1 (mipsel). I found a newer version on debian.org, 2.27 (mipsel), but that doesn't fix my problem so I doubt finding 2.26-21 for the ER-X (mipsel) will either.

The problem I have is that some WiFi clients don't work on some APs. They work fine when I'm using the AT&T router for 802.1x authentication. They worked fine when I was using the ER-X as an EAP-Proxy to remove the AT&T router. So the problem seem to do with the wpa_supplicant configuration or software.

The problems these WiFi clients have is that they can communicate with the LAN and everything up to the ER-X's public IP address. But they can't reach a single thing beyond the public IP on the ER-X.

I've tried rerunning the basic setup wizard and even done a full factory reset with the reset button.

I'd appreciate any insight or suggestions for things I can try.

I'm on a EdgeRouter X v2.0.8-hotfix.1. I have a dd-wrt WiFi router and a Milo WiFi router that can themselves connect to the internet but WiFi clients of theirs cannot when I am using the ER-X for 802.1x authentication. I have an openwrt WiFi router and some WiFi clients work with it. Let me know if you need any more information or clarification.

https://www.devicelocksmith.com/2019/01/configuring-8021x-authentication-using.html

Edit: Looks like it had nothing to do with my ER-X. I removed a wifi access point that had dd-wrt. Replaced it with another AP with dd-wrt and now everything is working. I have no idea.

Posted May 22, 2020, 6:43 PM UTC · edited

56
Loading comments…