Some spooky ambient music I made with LZX Vidiot generating visuals. Any tips for making more engaging visuals with the vidiot without video input? I was trying to make visuals only using video synthesis and it feels slightly... flat. Any advice would be greatly appreciated

Posted Jul 11, 2020, 6:42 AM UTC

2524
jaspmf•

Have you experimented w/ camera feedback? I know you said no video inputs - but a security cam heading in & pointed @ the TV sure does add alot of dynamic potential.

5
wardisonOP•

I have, and you're right, there's a lot of cool visuals that result from that configuration! I'm in the middle of moving so my camera is packed away in a box somewhere. I thought I'd use this as an opportunity to challenge myself to make a video without any video input.

3
brokenmixer•
  • feed frequencies around 50Hz (say 49.5Hz-50.5Hz) to Horizontal CV In and Vertical CV In and then play with the Pattern Generator. Multiples also work well. To generate them, I use phones and tablets with a free app called Signal Generator. I use an audio mixer to mix them and I route its output to the CV Ins
  • same technique as above, but with lower frequencies around 1Hz, as an LFO to modulate colors or contrast or luminance. With my phones I can't slower than 0.7 Hz, but if you have real CV oscillators you should have more luck
  • route Luma out (on the back) to Horizontal CV In. It creates a weird wave which depends on the luminance of the Luma Processor output. Modulate the luminance to change the wave shape. The single RGB outputs can also work

​

I thought I'd use this as an opportunity to challenge myself to make a video without any video input

that's a great idea ^^

4
wardisonOP•

tons of great experiments in here! Thank you so much for all the wisdom. I'm gonna try these out now!

1
laakso•

Its very nice! Is this only Vidiot? Can you tell us more about the patch?

2
wardisonOP•

Thanks for checking it out! Absolutely! Vidiot is the only video synth module but it was receiving voltage from my eurorack patch. Random voltage from Mutable Instruments Kinks was changing the frequency of the horizontal oscillator on Vidiot. This random voltage was also being sent to a couple of the colorizer inputs (blue and green? I forget which). The red and green outputs are being fed back into the solarizer and luma processor for some feedback as well. The square wave from the horizontal oscillator on the vidiot was going to the FM input on the vertical oscillator. There may have been more but sorry thats all I can remember!

1
abaracibo•

What you using for video capture?

2
wardisonOP•

*shutters* my phone. I normally use a dslr camera for moderately better quality. Any recommendations for a decent video capture card?

0
brokenmixer•

This is not "a decent" piece of equipment, I bought it because it was the cheapest one ever. Sometimes it lags a lot and I need to replug it. Apart this, it's been doing its job for a few months:

https://www.amazon.de/dp/B07DC1CCYM/ref=dp_prsubs_3

2
wardisonOP•

https://www.amazon.de/dp/B07DC1CCYM/ref=dp\_prsubs\_3

Oh sweet thanks for sharing that! I didn't realize a capture device like this would be so affordable. I'm definitely ordering one

1
abaracibo•

Elgato usb 2.0 is less than $100 and not too bad

2
wardisonOP•

I'll have to check that one out! thanks!

1
victorgrigas•

1.) Get stackable cables 2.) get a 6-way cable hub 3.) get rca-to-1/8” adapters. Any of these will magnify what you can do

2
basement_vibes•

What do mean by "stackable cables?" Is that where the rca has like a passthru on one end?

2
wardisonOP•

1.) good note! thanks. 2.) done and done! 3.) any recommendations or patch ideas for implementing the rca-to-1/8" adapters?

​

Thank you for the suggestions! Much appreciated!!

1
victorgrigas•

Ya plug the rca into anything you find at the 2nd hand shop that has rca out, and plug that all over the Vidiot

2
wardisonOP•

right on! Thanks!!

2
Peter_Lightning•

Looks cool, try turning off the sync.

2
mestlick•

I'd work on shape modulation from the Eurorack. Pitch, envelope, LFOs, really any CVs from the audio patch into the H and V frequencies and key levels to change the shapes based on what is generating the audio.

2
wardisonOP•

Thanks for the tips!! Greatly appreciated =)

1
[deleted]•

[removed]

1
Agawell•

if you have a eurorack audio synthesizer system - then you can use that for modulation (you may want to reduce the range with an attenuator) and in some cases for processing video signals - you will just have to try it - you won't damage anything (it's just electricity) - in a lot of cases you will get smearing effects and results will differ considerably - I particularly like the doepfer a-116 and a-136 - wavefolders are particularly effective

1
wardisonOP•

Oh good thought about the wavefolders!! I never thought about using that on a video source! I am going to try that! Thanks for the tips!! =) very useful

1