Calibration Cube prints with a pattern of wavy or diagonal lines
Posted Jul 17, 2020, 11:06 PM UTC
15
The freebie filament isn't any good, try a different roll.
But that said, could also be under extrusion, check your e-steps
1
it wasn't much worse than the freebie. But it got me on the right track.
E-steps were of by a lot. thank you!
1
Make sure "E in mm3" is disabled/off.
1
that improved my results. My E-Steps were way off as well. Thank you!
1
This is a new printer, ender5 pro. The cube was printed with the stock Creality filament.
The bed is a nightmare to level, but every print i make has a little corner lifting, and poor resolution, gaps here and there on the bottom plus the wavy pattern.
I am on mobile but will try to upload an album with all the faces of the cube.
edit: imgur gallery calibration cube