Accidental permanent attachment.

Posted Jul 19, 2020, 9:42 AM UTC

Posted Jul 19, 2020, 9:42 AM UTC
[deleted]
Easiest way right here. Wopd is organic and constructs when cold and expands when warm.
[deleted]
Done this many times, I just heat the glass around it to get the moisture out and then leave it out to dry for a few hours.
Waited a few hours after heating the glass adapter and it popped right of :) thanks for the help frents!
Gently heat the glass while holding it with tweezers. Once it become warm enough you should be able to pull the dyna out
I suspect the wood will expand more due to heat than the glass.
Tried this. Heat doesn’t seem to do the trick. Maybe I’ll just break the damn glass thing.
Heat causes expansion, cold causes contraction.
Put it in the freezer for 20 minutes.
Heat makes wood contract, and cold expand it. In theory
Edit: its in reverse. My mistake
Lol
Anyone got tips on how to remove the wooden stem from the glass adapter?
I got my hydra wet and it stuck in a 14mm piece. I heated the outside of the glass with a torch around where the swollen wood made contact and after a few cycles of this, it dried, shrunk again and popped out.
This is what worked for me when mine did this.
Freeze it
[removed]
Maybe first try a vice, haha? Wrap the wood stem in paper towel or cardboard and GENTLY put it in the vice and then try pulling the glass. I dunno, I'm high but this is what I'd try
I don’t have one. But I’m thinking of just crushing the glass adapter. A vice could be helpful with that as well ;)
Add a little oil drops from top of glass adapter. Any cooking oil like mustard or canola. if you ok with wd40 or lubricant oil add that. But You have to clean thoroughly after it removes
Let it absorb for an hour or so. Try again with twist motion, heat as well if needed
wd40 is great for these kind of problems and many others too. its like a liquid multitool.
Engineer here. Percussive shock (mild) is your friend here. Find yourself a bottle with an opening that is large enough to fit the Dynavap (tip first) but small enough that the glass adapter does not fit. Then, get yourself something small, like a big stirring spoon or something, and just tap the mouthpiece of the Dynavap until it pops through. You can either progressively tap harder or find progressively heavier things to tap it with. Should pop out with relative ease.
This
Second. Added too, a plastic bottle would be better than glass, really. Even a plastic tube of the right size and length would work.
Yep. A plastic coke bottle would work perfectly, I suspect.
Possibly try lubing it with vasoline? As long as you don't keep it on there I don't see it doing any harm to the wood. Also if you don't have any attachment to that adapter you could probably smash it without damaging the dynavap
Careful, just did this and stress cracks formed around the joint of my bowl. Obviously if the glass is so stuck and your hitting it from 1 side, it may or may not directly transfer the energy your giving into the stuck joint and stresses the next week spot.... I prolly shoulda 3d printed the exact od sized insert to use
[deleted]