r/Moissanite•
rtiftw

Help/ Advice/ Guidance and Expertise please!

Looking for Advice

Hi all,

I have been lurking on this sub for a while now as a ring has been a long time coming. I am finally ready (hopefully with a bit of help from you) to have a ring made. Likely with Starsgem or Tianyu...

After doing some research these are my thoughts for a ring (I'm open to any and all advice and am willing to accept that what I'm thinking is absolutely banana-pants-crazy).

Here's what I've come up with:

Basically I could use your advice and input on what I've proposed further guidance about sizing and measurements. And any other alternatives, insights or words of wisdom you might have about the ring itself or the process would be appreciated!

I'd like to get as close as possible to the final product as possible before beginning the process. I've seen a few posts about increased costs and unexpected and unpleasant surprises and if possible I'd like to minimise that risk as much as possible.

Thanks a ton for taking the time!

Posted Jul 20, 2020, 4:00 PM UTC

52
serelliya•

Your current plan looks pretty good. A few comments:

- The "pointed setting" from your link shows double claw prongs. Do you definitely want double vs. single claws on each prong? For a 6.5mm round stone, the double prongs may cover up a lot of the stone.

- It's risky to do a pave band with Chinese platinum, so good on you for not doing that! A knife edge band is also a great way of getting a thinner top view with the sturdiness of a not-super-thin band. Only thing to watch out for is that if the wearer has sensitive fingers, you might want to taper the knife edge on the sides of the ring to a softer/more rounded finish.

- Do you want a band to be able to stack flush against the ring? Currently both of the photos you link have a little "donut" at the base, which will prevent a ring from stacking flush. Here's an example where the donut has been removed to allow flush stacking: https://anuevajewelry.com/collections/settings/products/plain-evergreen-4-prong-solitaire-stackable-setting

- After you decide which vendor you're going with (i.e. gotten quotes and picked one), ask to first pay for only the CAD. It should cost around $25-50, and is non-refundable but will be credited towards the total cost if you move forward. The CAD should show a platinum or gold weight number on it in grams. I've only seen one instance of an unpleasant pricing surprise that happened post-CAD; usually the issue is that you get a lowball initial quote and the ring design, once it's created in CAD, actually weighs more than they accounted for. So getting a CAD with accurate metal weight should help with most pricing issues.

2
Natural-Ad4062•

I think to minimize the risk of price increases, you could give them as many details upfront before they draw the CAD, such as thickness, width, etc (I know many people here if you look at CAD checks advise not to go under 2.0mm post polish).

I worked with Kelvin from Starsgem and had to make a slight change post CAD approval even, and he didn't charge extra. However he did say if it had been a day later he would have to charge extravsince they were about to start production.

1