I think I figured it out. After about a day or so of use my board asked if it was a .151 ohm coil. I think it needed a little “break in” because it was reading .161 ohms when I first built it.

Mesh has almost instant ramp up.

Mesh in a profile should give you a more cooler vape.

I dunno the problem you are having.

More surface area of the mesh probably, I'm guessing... Reduce the temp a bit

I just built my new Profile RTA and have it setup with the nexmesh SS strip. I know that SS and mesh increase the ramp time tremendously but the heat off of the mesh seems more intense than with SS coils in my Blotto.  Just for reference I'm running it on the Odin Mini on SS 316 mode. With the Blotto I can tell when the heat stops increasing, but the mesh seems to just keep going.

Profile RTA and Temp Control Heat