Issue with Clubsport base. Disconnects after turning a little.. Where am I going wrong?
Posted Jul 23, 2020, 3:14 PM UTC
112
I don’t know much about steering wheels but it looks like it’s turning to far and the thing to stop it is broke it missing
1
It doesnt work like that, and thats nowhere near the max rotation
2
I only have a cheap wheel that can’t rotate once the stop is at the bottom like I said I don’t know much
1
High end wheels have 1080 degrees of rotation.
1
I assume it would be able to turn a bit more than that though? The wheels only turned a half rotation. I assume somethings broke but I have no idea what
1
Is SEN set to 108 on the wheel settings?
1
It was set to 270 or something but I increased that to 900, still the same issue.
1
That’s unfortunate. Have you tried uninstalling then reinstalling drivers? I had issues on initial set up. I turned the base off, unplugged the USB, uninstalled drivers, plugged the base back and turned it on. My hardware’s firmware also updated.
1
I'm just about to remove them all and try again! Hopefully does the trick.. It's also been suggested it may be a power supply issue?
1
Found the culprit lol https://imgur.com/a/VtieT09
1
Found the culprit lol https://imgur.com/a/VtieT09
1
So my boss just bought this Clubsport V2.5 from a friend of his and asked me to set it up. It seems to disconnect after only turning it 270. I've played around with the calibration settings but this doesn't seem to increase or decrease this. I assume it's an issue with the base?