3s Motostryke mod
imgur.com/a/HNyCrjcPosted Aug 7, 2020, 5:50 PM UTC
256
Posted Aug 7, 2020, 5:50 PM UTC
18 AWG wiring and 10.1a Cherry submini switch. Not sure what kind of performance gain we are looking at here specifically as my chrony hates megas but it certainly sends them harder.
I believe it should be a 10-20 improvement (from American Foams review)
Any luck fixing the crappy trigger?
Not yet but I haven't attempted to fix it either.
I’m not much of a modder so I’m waiting for some solutions I can try.
The flywheels in this blaster look a lot like the ones in the Mastodon. Are they also similar in terms of construction, in particular with thin plastic webbing immediately around the hub of the flywheel which grips the motor shaft?
That plastic webbing can break easily and was a common point of failure for the Mastodons that we had back when I worked at battle sports. The plastic used in Mastodon flywheels could be bonded with devcon, but getting the alignment right after they broke was nearly impossible. I ended up preemptively reinforcing the flywheels by placing a ring of devcon around the shaft gripper, which worked quite well.
If these flywheels are similar in construction, then this might be a worthwhile thing to do here too.
Also, that geared pusher is good news (assuming that it works as well as the one in the Hailfire). The Hailfire pusher is easily the best manual pusher mechanism I've ever seen and it's good to see that it'll not only continue to be available, but do so in a blaster that'll be relatively easy to convert into a Stryfe replacement.