PETG first layer moving around

Discussion

Hey! I am completely new to printing and just tried my first prints but everything failed.The issue I am having is that it keeps dragging the strings around and messing everything up and then it clumps together. I've yet to be even near a good print using PETG. I used the included PLA i got in the box and printed the dog that was included and it turned out perfect. But as soon as I switched to my PETG this issue started happening. I tried adjusting the settings slightly but I kept having the same issue of it moving the string and object and not directly sticking to the bed.

Device: Ender Creality Pro

Filament: PrimeCreator Easyprint PETG

Software: Cura

The first settings i tried were the following.

Speed: 40mm/s (i think that's the right unit)
Fan speed: 20% (I tried everything between 0-100% but it turned out the same)

temp: 225 (as recommended)

bed temp: 70

Nozzel to bed: I leveled it using around 2 sheets of paper and made sure it was even.

Posted Aug 12, 2020, 9:17 PM UTC

14
Rhoihessewoi•

You are most probably too far away from the bed. The right distance is important with PETG. "2 sheets of paper" could be 2 sheets too far. :)

And I suggest 20 mm/s and no cooling for the first layer.

1
PhoenixFlRe•

https://all3dp.com/2/petg-print-bed-temperature-all-you-need-to-know/

More specifically the part on "Build platform temperature"

1
lazztoo•

Been there done that.... put tape on the bed and it will work. Filament quality is a big deal too.

1
Spark_77•

Temperature probably could do with being a bit higher - the petg I have prints better at 240 but you may not be able to go that high because the bowden tube will melt.

Speed is ok but make the initial layer speed much slower - I'm using 10mm/s at the moment.

You may need some adhesion help - I couldn't get anything to stick to my glass bed or blue tape until I started using Elmers disappearing purple gluestick. I'd probably try that first to be honest.

1