r/Cisco•
Maggost

Cisco Aironet 1850 series Access Point - How to access the interface management?

Question

Hi all.

​

I would like to know if someone can help me to get this issue solved, I'm trying to get the access to the interface management of this device, here are the things that I've tried:

​

  • Connecting to the wifi network by using the default password, I can connect but then what? tried to open a localhost page with chrome and IE 11 and it didn't work.
  • Connected through an Ethernet cable in the POE socket, did an ipconfig to find the current IP and tried to open a page with Chrome and IE 11 and it didn't work.

​

Thanks in advance for any help.

Posted Sep 8, 2020, 9:00 AM UTC

16
1
MaggostOP•

Thanks for the answer.

​

But I'm unable to understand how can I access the interface management, it seems that the AP was already configured in the configuration wizard, because it has a custom IP so I could not go through it by using the default IP address which is 198.168.1.1.

​

Now, after that procedure, on the website it says something about "Cisco mobility express software", it says that I could get it by connecting through the console port and to a laptop with an Ethernet cable. No success so far, tried to open a website with its custom IP but I can't access.

1
Bottswana•

You need a serial cable. Get a Cisco serial cable from Amazon or similar and actually look at the console and see what it’s doing.

It’s almost impossible for us to guess the state of the AP, which management interfaces are enabled, what IPs it has ect.

All recovery and initial setup of Cisco products are usually done over serial for a one off single product.

1
ciscophreak•

First, is it yours? Is it lightweight? If it is, management may be disabled. What are you trying to do?

1
MaggostOP•

My colleagues left me this task for today to see if I can manage to enter on the interface because the only person in the office was me.

1
SirDickButtFarts•

Enterprise AP's can be complex at the best of times.

Can you ssh into the AP? Download putty.exe 192.168.1.1 user Cisco pass Cisco.

If user or pass are wrong, reset the AP (Google it)

When you get in type "show version"

See if it's in lightweight or autonomous mode, if lightweight there will not be a GUI that you can access via web browsers. You will need to upgrade the 1850s IOS to an autonomous version. (Again google it).

​

Hopefully this will get you started at least.

1