r/motorcycles•
ky321

Is there such a thing as putting in too many miles too quickly?

Say a bike A is ridden 3k miles per year for 5 years and bike B is ridden 15k miles in 5 months. Is there any significant difference in the type of wear & tear as long as both bikes are serviced at the appropriate internals?

Posted Sep 29, 2020, 4:58 AM UTC

812
Schleberger'09 Suzuki VStrom 650,'12 H-D Sporty 1200,'15 Aprilia Tuono 1100•

Bike B is likely in much better condition (given otherwise equal conditions).

There's this saying that 80% of wear and tear happens in the first 20km; longer distance riding puts way less strain on your bike than frequent short distance riding. So I'd much rather have a bike that was actually being used (not abused though) rather than one that's only been around the block each other week.

13
sotanezYamaha MT-03•

I doubt it. You should take it easy during the break-in period*, but that is all.

​

*The user manual of the YBR125 recommends stopping the engine every hour for 5-10 minutes during the first 100 miles.

6
incredibikecbr250 | ninja 650 | striple | r1•

Bike A may look better but it may still be one it's first tires plus many of the original fluid. I'd say bike B will run better due to being used frequently but the cosmetic may not be prime.

4
ky321OP•

I mean after 5 years wouldn't it need new fluids? My manual says either x amount of time or y amount of miles.

3
straikychanMoto Guzzi V85 TT•

Engine oil, yes.

But there's other fluids.

Brake oil, fork oil, maybe even crankshaft oil if applicable.

Very few service manuals dictate fluid changes for these on a time basis, though all of those should also be done at some point in time even on low mileage bikes.

I usually recommend changing brake fluid every 2-3 years at the latest.

1
MisterShineH2 Ninja ST2 Le Mans V50 Ténéré CB400F CD200 NMax125 CB125T •

Fluid changes are based on time/distance requirements, though for oil time isn’t important. so if bike A has been serviced properly, this won’t be an issue.

1
JamesStrangsGhostKLR650•

I would rather have bike B assuming its been properly maintained.

3
Pepper9187•

If we were in the 70s i'd say yes, but not anymore.

2
spongebob_meth'09 R6, '20 MT 03, '84 XL600R•

The wear and tear on the bike with a lot of miles is likely less. A fully warm engine is wearing at a drastically lower rate than one that is cold.

Most engine wear happens on startup. Highway miles are a lot easier than city miles and short trips. I am always weary of old vehicles with low miles.

2
WBseventyfour'15 Versys 1000, '20 MT-09•

There are two ways of basic degradation: miles, and time. Mechanical wear of the metal parts is mostly a function of miles, but plastic, rubber, etc. parts degrade over time.

2
MisterShineH2 Ninja ST2 Le Mans V50 Ténéré CB400F CD200 NMax125 CB125T •

No. Some plastic and rubber components may be ageing, though. Brake hoses, for example.

1
spartzan•

No

1