r/3Dprinting•
tekdoc

Residue on PEI build surface

Question

Yesterday I printed a part with white PLA and it came out perfect, but after removal left its outline on my (relatively new) PEI build surface. Before you ask, my Z-offset is set correctly and the part came off the build surface easily. To be clear, these are not scratches from the nozzle. The outline cannot be felt and can only be seen clearly when light hits it from a certain angle.

This was my first print with PLA on PEI. All of my previous prints were with black PETG and those left no residue. So is this normal with PLA? And is it just cosmetic? I am hoping this won't affect adhesion but I would like to remove it if possible. So far I tried cleaning with dish soap and then with 91% isopropyl alcohol but neither removed the marks. Should I try acetone next?

White residue after PLA print on PEI

Posted Oct 4, 2020, 1:03 PM UTC

25
Loading comments…