First mod on the Mars 2 Pro complete!
reddit.com/gallery/ji1atlPosted Oct 25, 2020, 9:12 PM UTC
Posted Oct 25, 2020, 9:12 PM UTC
Can you replace the fan with a different one ? I would like to make the printer almost silent.
Rly? You can see through it? That's no filter at all... Disappointing, Elegoo.
Took all of 10 minutes to remove the so called filter. Step 1: remove the rear black cover, 4 screws. Step 2: remove bottom screws restraining filter(4 screws) Step 3: loosen the top plate that contains LCD(4 screws) Step 4: remove fan & unplug! seal the filter vent with packaging tape and assemble.
What exactly is the purpose?
On the 2 pro and pro there is a carbon filter that pulls air from the building area, through a filter and outside. It doesn't really work. Immediately after powering on my machine I could smell resin fumes so I just removed the entire system and now there's no smells until I lift the cover off!
Doesnt it still need cooling? Is that a different air system? I heard it worked well.
No, that fan is solely for the filter. That filter might work well for some resins but my resins that I am using were smelly when in use.
Also carbon filters are a consumable so after time performance degrades to 0 then you have a fan just sucking up resin fumes and throwing them outside.
How much does that reduce the noise of the printer?
Not much at all, I didn't notice a difference unfortunately.
I ended up just disconnecting the fan and taping over the vent, left the not-really-a-filter screwed in.
I own a non-pro Mars and have never had the issue of photopolymer odor while the cover is on.
I'd say you can trust me as my girlfriend who lives with me already hates how obsessed I am with 3D printing stuff and if the apartment reeked of resin I'd probably have bigger problems.
Yeah, the carbon filter is a good idea just not implemented right on the pros.