Initial setup NEJE Master 2
Hey guys.. hoping someone will see this and can offer some guidance..
I just got a NEJE Master 2 and am having issues with the laser 'verifying' when I try to connect it to the NEJE software on windows.. I can't for the life of me figure out what I've overlooked or missed and was wondering if anyone has any suggestions?
I'm finding it rather difficult to find any useful information online about getting one of these set up and going.. Couldn't find their app on the play store either.. will probably have to manually install the apk file I'm guessing.
Thanks for any help or insight you guys can provide!
(pressing the red button homes the laser, pressing again gets it ready to do the little square NEJE TEST PASS, pressing a 3rd time starts the laser)
Posted Oct 29, 2020, 6:41 PM UTC
I am having the same issue fresh out of the box. Did you ever figure out the problem?
I had to update the drivers for the printer and then mess around trying to get the initial connection.. I think I was able to find the page for you.. try this:
https://wiki.nejetool.com/doku.php?id=nejelaser_master_2
You will need this driver: http://www.neje.club/download/driver.exe
latest Neje software for windows: http://www.neje.club/download/20201119/NEJE_V5.4.exe
Neje app for android: http://www.neje.club/download/20201119/NEJE_V2.5.apk
Good luck, let me know how it goes
Finally figured out what was wrong. I removed the control board from the frame to give it a detailed inspection and found one of the diodes for the CH430 USB to serial chip wasn’t soldered properly. After fixing that, the NEJE software worked fine and I was able to load the GRBL firmware. Thanks for the help.