r/ak47•
deck0352

Note to self. Stay away from refinishing whilst drunk

Note to self. Stay away from refinishing whilst drunk

Posted Nov 6, 2020, 11:28 PM UTC

4915
MrSilk13642•

Wtf did you refinish it with? A hammer?

30
deck0352OP•

+2 hammer of stoly

15
UgliestCookie•

A little titebond and some clamps and you're gonna to go bruh. Send it.

13
MolleShinobi•

Nyet. Wood is fine.

13
Hatetotellya•

All you have done is created an upper bayonet

Not seeing the negatives here

10
SlappyBag420•

Time to go cheese grader

8
_TheHalfTruth_•

East fix. Leave it on the tube, gorilla glue it, and get clever and find a way to clamp it. Happened to me, fixed it right up. Rifle is fine

6
jimipanic•

I agrees It’s fine. Allows heat to escape the gas tube better

4
Fullgore123•

Use a zip tie and you’re good to go comrade

5
Rnc88•

Great excuse to get an Ultimak!

3
Bruizer01•

Yeah, I’ve done that once or twice with My WASR-10. U gotta be careful with the single wood piece upper HG’s as Laminate is definitely of better strength and quality but these just belong on a WASR or G Rifle...🤷🏼‍♂️

3
deck0352OP•

Yeah, this is a WASR. It’s my first AK, after decades of guns. I’m enjoying the heck out of learning a new system, but it’s been a bumpy road. Lol. I got a little too zealous and was trying to move too fast. Was taking the plastic ATI shit off that I put on it, because I like the wood better. I do believe I will go the cheese grater route now. At least that’s a positive.

2
John_the_Piper•

The nice thing about the cheese graters is if you're drunk and pissed off while trying to install it and just hammer it until it fits (like I did) it only adds to the "aesthetic"

3
Bruizer01•

Yeah I own a Cheese Grater and the newer Hater Grater with the rectangle shape cut outs.. I like both but I have the Hater on my WASR now.. The only thing that might replace it is the Ultimak..

2
The_Alces•

nyet rifle is fine

1