r/buildapc•
acoops

Bitfenix Prodigy Mini-itx with RTX 3070

It's about time I went for an upgrade. Currently have a build in a bitfenix Prodigy case which I really like so would like to put the new build into it if possible. I'm looking at upgrading to a 3070 but having seen the size of the 3000 series cards mentioned in reviews I'm concerned it won't fit. Anyone have any ideas?

Posted Nov 10, 2020, 10:33 AM UTC

13
djax9•

I was just looking this up too... online it SAYS you can get up to 310mm in this thing... but I dont see how...I have a 2070 Ventus 2x in mine and at 226mm and it barely fits... There must be some sort of side configuration that works better but i couldn't figure that out?

I THINK you probably can get the 3070 ventus 2x in there...? (232 mm) probably in the second slot down which will cramp your MB.

edit: edited my numbers off the top of my head were off by a whole 100mm

1
djax9•

https://imgur.com/a/nnevQ6A

Nevermind I opened her up and there is more room than it felt when i was building her. There is a good two inches from the point of the ventus. Pardon the dust and my poor cable management.

So id say lengthwise anything 10.8" or 274mm and smaller will fo sure work..its the height (52mm vs my 42mm) that may be the problem. THERE ISNT 10mm of space between the top of my card and the case but its hard to say if that extra 10mm on the 3070 is all top... if its 5 up and down it could BARELY fit. If not you can always go second slot down... that wasted space makes me cringe tho...

1
ProfesionalPotato0•

might be a bit late. but i am Running a 1080ti strix quite happily in mine

1