2014 Impreza, what is going on here? Sound on
gfycat.com/delectableimportanthagfishPosted Nov 13, 2020, 11:51 PM UTC
Posted Nov 13, 2020, 11:51 PM UTC
Looks like your ac compressor engaging and disengaging. This is normal.
Even with the awful sound?
Not getting any sound from the video?
EDIT: Just checked this on PC and it has sound. Wasn't working on the mobile app for some reason? The awful sound does point to a faulty compressor. I would have the refrigerant evacuated and remove the A/C lines at each fitting to check for debris. If the debris made it's way all the way back to the compressor it's likely a big part of the A/C system (compressor, condenser, evaporator, expansion valve) will require replacement. Fingers crossed for you.
Gfycat is muted by default I think it works for me. Either way it sounds really loud like something is clicking really fast inside.
Don't listen to this
A/c compressors have a clutch system in them internally. The engagement may temporary slow down the belt but the pulley should always be moving.
Why would they design a pulley that doesn't move and wears down the belt?
When it's locking up its engaging a seized compressor and that's causing the lock
If you look closely at the edge of the pulley it is still moving. The face/clutch is pulled against the spinning pulley by an electromagnetic clutch and causes the engagement of the compressor when commanded by the control unit. This allows the compressor to engage and "pump/compress" the refrigerant that then flows through the condenser under high pressure to release the heat it captured from the interior of the vehicle. If the compressor stayed engaged all the time, the high side pressure would build and eventually blow the refrigerant out of the safety valve on the compressor. The video doesn't have sound so I can't comment beyond what I see happening and to me it looks like a normally operating A/C compressor..... But you probably shouldn't listen to me. I've only done this for a living since 2002. Have a nice day.
Daaamn you got me. Didn't check it, and your right.
I'll take the downvotes
You owned your mistake and that shows character. For that, you get an upvote.
Your a/c compressor is seized. A/c compressors are like little motors and they too can break down. A/C work is expensive because the fluid inside the a/c is bad for the environment. if your looking at doing this cheaply... there's ways to save alot of money putting it in yourself but that can kill the turtles.
As of right now you need
-a/c compressor
- new serpentine belt as its worn from rubbing like that
Are you looking at doing this repair yourself?
At a shop your looking at (in a honest shop)
A/C diagnostic -150
Compressor -250
Belt - 40
A/C fluid remove and replace - 200
Labor - 300
More than that. If his AC comp is locking up it will be sending metal down the AC system. The system will have to be flushed and expansion valve/orifice tube needs to be replaced plus air drier filter
This is true, but it may not have thrown enough material to cause further damage. Any shop will tell you it did though
Not necessarily damage. Just clogged filters and material that could potentially make it's way back to the new compressor. If the compressor is locking up its creating a ton of heat. And in my rather short experience with AC a system that gets too hot makes some weird black powder. I think its burned PAG oil but I'm not sure. But it destroys systems if it goes on too long. Locked or broken(yes, broken. Like broken pistons) compressors, clogged evap cores, condenser cores, orifice tubes, expansion valves. People keep telling me the black powder is broken down AC lines but that is a load of bullshit because older buses with original lines come in for a regular service and dont have that shit anywhere. I only see it on systems that regularly overheat
Does this black powder come out when releasing the Lo-port or do you just see it in clogged cores?
Sheesh. This car has been a massive headache.
I don't mean to kick you while you're down but this issue is usually due to the receiver/drier leaking and causing a loss of PAG oil that is used to lubricate the internals of the compressor. If this is the case the condenser will need to be replaced as well.
-Subaru tech that has dealt with similar issues.
Well it is what it is. how's 2014 imprezzas usually? This car had been a disaster. Also it's clunking/lunging at 2k rpm recently.
[deleted]
Looks like the clutch is going bad you didn't recently refill it with freon did you?
Girlfriends car but never touched anything other than the brakes and oil
Thanks for posting on r/MechanicAdvice! This is just a gentle reminder to review review the rules. If you are here asking about a second opinion (ie "Is the shop trying to fleece me?"), please read through CJM8515's post on the subject. If this post is about bodywork, accident damage, paint, dent/ding, questions it belongs in r/AutoBody or r/Diyautobody If you have tire questions, check out r/howsmytire and ask there.
I am a bot, and this action was performed automatically. Please contact the moderators of this subreddit if you have any questions or concerns.