NR200P Temps improved by removing a case fan

Benchmark/Thermal Test

I have a 5600X cooled by a Big Shuriken 3 + NF-A12. I used to have two Arctic P-12 for case fans at the top, and that's it. Also using the vented side panel. I used to see gaming loads of low-70s. I have a EVGA 1080 FTW3 shoving hot air up too.

On a whim (well, minor suspicion), I removed the case fan above the cooler, leaving just one case fan in the system (above the PSU). And, the temps dropped by 5'C.

The NF-A12 doesn't improve temps compared to the stock scythe kaze flex slim. It' simply silent.

Posted Dec 25, 2020, 6:21 PM UTC

45
SurpriseHanging•

That's how I set up mine too, since I thought that a case fan directly on top would disrupt the airflow of the BS3. Was that P12 intake or exhaust?

1
leafcutter64OP•

The P12 is exhaust, shoveling the hot air from the gpu/cpu out.

1
jmer311•

That benefit is most most likely due to the top down cooler design. I found that my CPU temps (also running a 5600x) go up to 2-3 degrees if I remove the fan above my Noctua U9S mini tower cooler

After trying every orientation possible in this case, 2x P12s at the bottom (intake) and 2x P12s at the top (exhaust) have provided the best temps by a little bit but the best acoustics by far

1
leafcutter64OP•

I think you are right. The most benefit from removing the case fan above the cooler is because the BS3 is a top-down cooler.

1
sbuxty•

I've got a fuma 2 with top exhausts and I might try this too actually

0