Strange Behavior - Stuck in far right and extrudes

Hey All!

​

Hoping you can help me with this. For some reason all of my newly sliced models out of cura are doing this where it'll go through its standard warm up procedures with the BLTouch and then the nozzle will move to the far right and just start extruding filament out. As you can see in the picture I have the all metal hotend on here and the direct drive extruder but older models like my calibration cube printed fine. I have been looking online for a solution and there isn't much out there. I've tried reinstalling my slicer and wiping all the previous configurations and I still have the same thing. Any and all help is greatly appreciated!

​

Side Note:

I would like to note that this printer has been driving me nuts with all of the changes I've needed to make on it just to keep it running. Things just randomly break on this thing and I will need to go in later and replace them with upgraded parts. I've only had it for a few months. Maybe this is the world of 3d printing but I have to believe that I am doing something wrong.

Where the nozzle stops and starts extruding out filament rapidly.

Posted Jan 23, 2021, 4:11 PM UTC

13
jagger1973•

Sounds like you're stuck in the incremental mode, but you need to be in absolute mode. Get Rid of that G91 in your Start G-Code. Once you do that, cycle the power on your printer just once before your next print. (Or send a G90 if you know how)

2
FootCallusOP•

OMG that may have fixed it thank you soo much!!

2
FootCallusOP•

Here are my cura settings as well if that helps.

​

https://imgur.com/a/uOVNFSP

​

I am running on firmware version 1.1.1 off creality's website and its the 4.2.2 Ender-2 v2 Marlin 2.0.1 BLtouchV1.1.1without adapter board firwmware.rar if that helps.

1