Printer Stopping mid-print

Discussion

For all my prints and at random times my Eryone Thinker SE printer will stop and say "Power loss" resume print. This is despite the printer being plugged into surge protection and the printer being on the proper power setting - any higher and the printer flickers basically. Does this mean the power supply has gone bad or firmware issues? It's a new printer.

Posted Feb 18, 2021, 12:33 AM UTC

12
hmspainPrusa Mini, Prusa i3 MK2.5S MMU, Prusa i3 MK3, Form 2•

It may very well be a printer issue, but I would always recommend a small UPS for any 3D printer.

Something similar to:

APC UPS via Amazon

1
Concussion909OP•

Yeah I have a Cyberpower surge protector and battery pack that it's plugged into =)

1