r/HVAC•
NitroMeta

Goodman outdoor heat pump won't stay in "test" defrost longer than 3 seconds?

Hi as title states this goodman has me bangin my head. I'm trying to test the defrost and when I short the test pins together it shifts over only for 3 seconds then goes back to regular heat mode. Installed a new defrost board and still does the same thing. Does anyone have any idea what I should check next or what causes this?

Posted Feb 24, 2021, 8:12 PM UTC

25
wweelltthheenn•

Test probably only runs until the coil temp sensor is at its design temp.

5
Smawesome•

If you ever think the board is bad replace the sensor(s) aswell.

3
NitroMetaOP•

That's probably a good rule of thumb.

1
se160•

I was just dealing with this yesterday. You have to put the jumper in the test position and once it starts defrost mode immediately take the jumper off the board and leave it off, it will then stay in forced defrost for about 5 minutes regardless of sensor resistance. When you’re done put the jumper back in position of 30/60/90minutes.

2
NitroMetaOP•

I just tried removing the jumper tool the second it went into defrost and it stayed in defrost. Thanks

1