Starting the process of Pulling this 289 today.
reddit.com/gallery/lt7tddPosted Feb 26, 2021, 9:05 PM UTC
Posted Feb 26, 2021, 9:05 PM UTC
You cant kill a properly built 289. They'll spin 8000 rpm from the factory, two bolt mains and all. There isn't enough reciprocating weight to break and the piston speed is very low.
I say that because to make HP with a 289 you gotta rev.
If you're just looking for a cruiser nevermind this post. If you want to go fast, get some aluminum heads and a healthy camshaft and rev the hell out of it. Factory iron heads are terrible. Porting cant even save them.
If you want to go slow, keep factory iron heads and a stock or little cam. Keep the RPMs in the grocery getting range and don't scare grandma.
Any “must haves” on the next engine/ engine bay? Let me know!
I just got a set of 2AWG cables (kind overkill) to go from the battery to master ground, positive to ingnition solenoid, and solenoid to starter. The motor spins over like it should have been running yesterday while the stock cables struggled to carry enough current. You can buy custom made with length/terminal ends/and choice of black or red from batterycablesUSA fairly close to the price of stock replacement cables if i remember correctly.
This is exactly the type of tips I was looking for. Thank you my friend.
How do you like the sniper? Last shop I bought a carb from screwed me but I’ve been thinkin of picking up a sniper.
Here’s the issue. I bought the sniper to quit messing with carbs, flooding etc all of that.
I got the sniper and learned that my engine was producing such little power that it couldn’t keep the sniper alive sometimes. Other than that I loved it, never had to worry about if it would start once I turn the key, no need to pump the gas, the little screen it comes with gives you a awesome amount of information on top of that so you can keep an eye on all your temps, power, vacuum etc.
If you drive your car a lot then I’d say it’s worth it.
Good to hear! I’ll have to pick one up for sure in the future.
I am pulling my 289 out of my 65 next week the oil pan is really banged up I need to replace that and I will be replacing the 2 bbl carb with a sniper kind of worried about that part I hope I’m doing the right thing I am also going to spring for the Holly gas tank