r/Magnets•
HOGCC

Need magnets to pass through a few mm of plastic

I think magnets will be a good solution for me, but I’m not sure if it is feasible, or if it is, what type of magnet is right. I have a carpet dashmat on one of my vehicles (TJ Wrangler). It slides around when its windy, and sometimes even falls just from turning; It’s very lightweight. I don’t want to velcro it because I want the dash clean when it’s off. I was thinking of epoxying a magnet to the corners on the bottom of the carpet, and under the dash plastic (very easy to remove; it just pops on/off) so the vehicle side magnets would be hidden when the carpet is off. The magnets force would need to be able to pass through a couple millimeters (like maybe 5mm or so?) of the plastic though. What kind/size of magnets could work for this?

Posted Mar 26, 2021, 7:36 PM UTC

37
Thirsty_Comment88•

Neodymium magnets will work great for this. Check out home depot they usually have a selection of small size magnets that will be perfect for this.

https://www.homedepot.com/p/Master-Magnet-0-47-in-Neodymium-Rare-Earth-Magnet-Discs-6-per-Pack-07046HD/202526367

3
HOGCCOP•

Perfect!

2
applied_magnets•

There are a number of variables but this might be a good place to start - Rare Earth Magnets 1/2 in x 1/2 in X 1/4 in Neodymium Block N42 - Applied Magnets - Magnet4less

If you put a magnet on both sides you have 15lbs of pull force (there is a drop off for the 5mm to about 3lbs). If that's too much you can use the magnet under the dash and a metal plate on the cover which would make it 1.5 pounds approximately . You can order a few sizes up or down to try different sizes - the following page is a list from smallest to largest.

Neodymium Block Cube & Bar Magnets - Applied Magnets - Magnet4less

1
HOGCCOP•

Excellent, I was afraid the gap would make them useless.

1
applied_magnets•

You are going to have a drop off but 5mm should still be close enough to have a decent amount of pull force left - especially for what you are attempting.

1
11th-plague•

Make sure the magnets don’t interfere with the dashboard lights, sensors, dials, etc.

They are powerful :)

Also consider suction cups if the dash plastic is smooth.

There are also polymer plastic-like things that you can get in the shelf-liner aisle in hardware stores and dollar stores that help carpets stick to floors to prevent sliding.

1
HOGCCOP•

Good tip. I don’t think they will, it’s a relatively low tech dash- a 2000 Wrangler. But I’ll verify before epoxying anything.

1