poorbredOP•

Warm resin, burnt off the bubbles with a lighter, and dabbed some on the inside of the cap part of the mold. The pot was at 35 psi. Yet I get this so often.

3
stratospaly•

Degas your resin with a vacuum chamber. The pressure pot makes the bubbles smaller, that space is taken up by resin, that can leave a void at the top of the mould. I prefer spree molds to cap molds for this reason.

2
poorbredOP•

Hmm. Might have to go with sprues for now.

2
KathrynKnette•

There's a combination sprue/cap mold that has the best of both worlds. Just put a pointed hole in the cap.

2
The_Druid_of_Fluid•

For a tutorial on this I recommend this video by Firebolt Dice: https://www.youtube.com/watch?v=LRlnsbvEeh4&list=PLwg6hs2JOYbEOq6QvwhmkglkmNLjBSvBP&index=5

3
The_Druid_of_Fluid•

Also I would say generally I think I have better results with my cap molds if I use the resin after it is tacky (waiting 25 minutes or so). I think this helps when I put extra on the cap before closing and putting everything in my pressure pot as then it doesn't spread thin but fills the gaps in. Good luck, practice makes perfect!

3
poorbredOP•

I have been considering those. One question I had though was, if you're doing something like a dirty pour, how obvious is the location where the sprue was? I envision that there'd be a circle where the resin flowed down and into the mold that might contrast with the rest of the die's appearance.

1
KathrynKnette•

That's an excellent question that I wish I had the experience to answer. If I get my new molds up and going, I'll try to answer as soon as possible.

My guess, however, is that it might not change much. Not much really flows in, and it'll still be able to move around when it does. Not to mention, when you press the sprue caps on, a bit of the resin will flow upwards into the sprue (assuming you overflowed it like a proper cap mold).

Edit: I made some sprue cap molds, but I came across the problem of the face lifting that I just didn't have when I made cap molds, so I've dropped the sprue entirely. Sorry.

2