I have a kicker cx600.1 and currently have two 10" Kicker CompC subs. I was told that those aren't the best subs for my amp and the amp could damage them.
So my question is, what should the specs be for the sub I will get? I want to make sure I am searching for more compatible products
Posted Apr 15, 2021, 2:36 PM UTC
Rockford fosgate p3 would be a good fit or JL w3v3d2 i think there only svc. P3 is dvc
Is the single coil any better/worse than the dual coil?
You can say dvc is better than svc bc of the wiring options u can wire a dual 2 ohm to a 4ohm final load or 1ohm final load , a svc u would need 2 subs to achieve that.
OK. When you said Rockford Fosgate P3.. did you mean the P3 line? Cause I see a bunch of P3.. P3D4, P3D2 etc
If you plan on running one sub the dual 4 the wire it down to 2ohm to get the 600wt rms. P3D4
They slam i had two of them on a rockford 600.1 and man they blew away 1000wat speakers.
Look for something that fits this. I personally would try to find a single 2ohm 12 or something, but my taste might be different from yours.
RMS Power
@ 14.4V, 4Ω mono, ≤ 1% THD+N : 300W x 1
@ 14.4V, 2Ω mono, ≤ 1% THD+N : 600W x 1
Any reason for 1 sub instead of 2? You prefer Localization of the bass?
I'd rather give a speaker the 600 watts and get the most out of my money.
Makes sense.
Subbass frequencies are not localized like higher frequencies. The wavelengths are measured in feet.