sheldonopolisOP•

You need:

  • 1 5v capable FTDI USB serial adapter

  • 1 Diode 1N5817 (optional but might cause problems in some instances otherwise, like when having connected more than one SIO device.)

  • 1 SIO plug

  • preferably solid core wire, holds the FTDI in place nicely.

Wired up like this:

  • TX - diode (stripe towards the FTDI) - pin 3 Data Input

  • RX - pin 5 Data Output

  • GND - pin 6 Ground

  • CTR - pin 7 Command

  • DTR - pin 9 Proceed

  • VCC - NC

SIO connector pinout.

The FTDI might need to be set accordingly to run at 5V. I just removed those pins and bridged the contacts for space. The plug then needs a little grinding at the sides to make room for the FTDI but its not much work. Before you ruin a perfectly good cable you might opt for buying a plug on ebay. You might glue the board in place if things arent snug.

Should roughly look like this.

It could be done a little simpler but this way it should work with handshake CTR, at divisor 0 and with all common tools (RespeQT, atariserver, Fujinet-PC).

2
matrixreloading•

What does it do?

1
sheldonopolisOP•

It essentially emulates a sio device, like a disk or cassette drive or also a modem if using a tool such as fujinet-pc.

1
BulletDust•

Are you using Fujinet-PC?

I'm running it on my Pi400 as well as RespeQt via my own home made SIO2USB cable and I love it. Although I will admit I mostly use FujiNet for it's R: handler emulation.

1
sheldonopolisOP•

I am using it though it seems sure somewhat buggy, which I guess isn't surprising since its basically in an alpha state right now. Seems not to like higher speeds but maybe thats the case because I am running it in virtualbox. Still very decent piece of software. I probably should try it on a Pi as well.

1
BulletDust•

I haven't encountered any bugs as such, it all seems as stable as an actual FujiNet in my case (which honestly, always seems to be in a case of perpetual beta). However, HSIO divisor 0 doesn't seem as reliable as RespeQt running off the same RPi using the same SIO cable - It 'sounds' OK (based on SIO pips), but I see baud rate renegotiations in the terminal window on the Pi from time to time.

1