Finally getting my printer dialed in and my prints still warp towards the back of the bed.
Posted Jun 16, 2021, 1:53 PM UTC
26
Iām using a creality glass bed with the special coating. I clean the bed isopropyl alcohol. Initial bed temp is 70. Normal bed temp 60.
1
Are your belt and pulleys tightened ?
1
I do 60 then 55 for normal PLA. When I did 60 and 60, i got warped corners.
1
The edge of your first layer still looks a bit rounded, try getting the nozzle and bed just slightly closer so you get a little more squish, which will greatly increase adhesion. Also, don't start the part cooling fan until layer 3 or 4, uneven cooling will also cause warping
1
try another table-top ! š is the "back of the bed" subject to a cold draft ? (cooling fans, airco, windows, opening doors,.... basically anything that can create a non uniform temperature footprint)?
1
Hello u/Dr_Codeman,
As a reminder, most common print quality issues can be found in the Simplify3D picture guide. Make sure you select the most appropriate flair for your post.
Please remember to include the following details to help troubleshoot your problem.
^Additional ^settings ^or ^relevant ^information ^is ^always ^encouraged.
I am a bot, and this action was performed automatically. Please contact the moderators of this subreddit if you have any questions or concerns.