r/bikewrench•
420boy

Dustcaps on only one side of rear hub?

I am overhauling a vintage freewheel hub. The non-drive side cone had a dustcap built into it. The drive side cone had no dustcap attached. There wasn't a dustcap attached to the cup either. But the bearings were in cages. I assume the bearing retainers acted somewhat like a dustcap on the drive side.

I want to replace the bearing cages with loose balls. Should I find a dustcap for the drive side or might it not matter as much once the freewheel is threaded back on?

Posted Jun 30, 2021, 3:32 PM UTC

03
ScootMaBoot•

might it not matter as much once the freewheel is threaded back on?

Yeah. A lot of the time the non drive drive side of a freewheel rear hub will have much better sealing than the drive side.

1
420boyOP•

thanks B)

1
nogasbiker•

I also noticed cases where vintage drive side doesn't have the dust cone. I too think it is because the freewheel surrounding it offers quite a bit of protection of dust.

1