Repairs Costs
Hi all.
My clutch just went out last week on my 2013 2.0T R-Spec at about 105k miles. I believe the issue is the throwout bearing, and not the clutch itself, however it it worth replacing the clutch along with it.
Here's what the dealership told me:
The slave was leaking and needs replaced, as well as the cutch AND flywheel...? parts for this are about 2900, and labor is 900. (3800 total).
Also, when I bought the car 20k miles ago, I had a different dealership do a full inspection and they said timing and trans were fine. Now this dealership said my timing cover was leaking and needed replaced, which is 200 for the cover and 900 for labor.
Am I getting screwed out of $5000 or is this correct? Would it be worth towing it to a local shop to look at it and possibly give me a better quote instead? I feel like I might as well do an aftermarket clutch kit for that price...
Posted Jul 1, 2021, 7:20 PM UTC
Just called a smaller shop, they said if I get a full kit, they'll install whatever I provide to them for 600 for labor. I might as well get a slightly more aggressive clutch as a kit with a flywheel for like 1500 at that point, right? Seems stupid not to for a fraction of OEM parts and labor cost.
My buddy told me timing leak is probably just from when they did the inspection (was at about 95000) and used the same gasket instead of replacing. It should be minor enough that I'm safe without it because my garage floor is clean, I'm not aware of my car leaking at all.
That is up to you...keep in mind any kit that doesn't use the dual mass flywheel is going to have more vibration and chatter...that's really just non-negotiable. Many people have luck without getting A LOT of that, but you'll still get some. I upgraded to the Valeo HD kit for mine which is still an organic clutch but uses the dual mass flywheel as well.
While you're in there, you might as well replace (and/or polyurethane fill) your engine mounts too. They have some aftermarket ones, but the OEM ones on rockauto were like $35 each when I bought mine.
Also, I highly double they took the entire timing cover off for an inspection...that's a good bit of work. Degrease it and spray the area down, apply some silicone, that is the easiest way.