I decided to return to basics to see if I do fundamental mistakes. Any critique is appreciated!

Studies
I decided to return to basics to see if I do fundamental mistakes. Any critique is appreciated!

Posted Jul 21, 2021, 8:31 AM UTC

24
TowaMatts•

Hi, good job especially on the cube. One thing I noticed is the light casting on the sphere looks like it's coming from a different angle, compared to the other shapes. If they are all under the same lightsource, I think the shadow on the sphere should be cast horizontally (or close to horizontal).

Another thing is that you are using two values for the top of the cylinder. I suggest using the same values for a flat surface facing the same angle like you did with the top of the cube. If this is a hollow cylinder, then you might want do darken the inner plane that is facing away from the light more. Lastly, the core shadow/contrast of the sideplanes of the cylinder seems a little too sharp for a round surface, so you might want to give it a gentler gradiation, unless it is made of metal. I hope this helps you :)

3
markedartemisOP•

Thank you, I’ll keep this in mind:)

1

Hi! Thanks for posting these. 😊

I think that the contrast is a bit high for this bright of a space. The values should be a bit closer together. Take a look at the cube. The plane facing us, for example, would be a bit lighter because of reflected/bounced light. You can lower the general value and then go over it with a soft brush to show the light that bounces off the floor/space and hits it.

3
markedartemisOP•

Thank you!

2