pontiacta77•

I did mine under the truck on my 96. The one in the diff had that problem. I cut it out with an angle grinder and cut off wheel. Pulled out the center of tge u joint. Then i pressed out the side pieces with a ball joint press.

2
ShinyKeychainOP•

Yes, I think that is the way. I'll need to pick up an angle grinder but that isn't bad. Then press out the remnants. Thank you!

1
AutoModeratorMOD•

Thanks for posting on r/MechanicAdvice! This is just a reminder to review the rules. If you are here asking about a second opinion (ie "Is the shop trying to fleece me?"), please read through CJM8515's post on the subject. and remember rule 3a, please post the year/make/model of the vehicle you are working on. If this post is about bodywork, accident damage, paint, dent/ding, questions it belongs in r/AutoBody or r/Diyautobody If you have tire questions check out https://www.reddit.com/r/MechanicAdvice/comments/k9ll55/can_your_tire_be_repaired/. If you dont have a question and you're just showing off it belongs in r/Justrolledintotheshop This is an automated reply

I am a bot, and this action was performed automatically. Please contact the moderators of this subreddit if you have any questions or concerns.

1
ShinyKeychainOP•

Used a tiger tool for removing ujoints. They are very rusty and old. I ended up breaking the ends off the ujoint caps. I'm not sure what to do at this point.

It's just the sides of the caps in there at this point. I have a press I can press them in on. Maybe that'll get them loose. But how do I get these out?

1
TundraFox_76•

As someone who owns a vehicle covered in more rust than average, I simply used a socket and a piece of wood and beat the hell out of it until the cap on one side came out, then worked the other side out and it should just slip out, depending on how much of the cap in busted off you may have to do as suggested and break/cut the u-joint out. I would suggest cutting first tesds to be more fruitful.

1
ShinyKeychainOP•

Since the end of the caps is gone I can't push it out like normal - pressing the one side won't affect the other side. I could press the end cap into the middle which might be what you're suggesting. But, I think with the universal joint still there it won't have enough space for both the end caps and universal in the middle. So cutting out the universal first seems like the way to go. It may be I have enough rust to be obnoxious and not enough rust to make it easier. Thank you!

2
NCC74656•

You can use an air saw or grinder to just cut the U-joint apart, if it's a zerk fitting joint, you could maybe even use a breaker bar and just shatter the thing. After that you can use a ball joint press to push the bearing cap material out or you could use a saw blade and cut the bearing cap material in 2/3, then use a flat head screwdriver to knock out the pieces

1
ShinyKeychainOP•

Sadly not a zerk fitting joint. I think it's going to be an angle grinder and then as you say press the bearing cap material out. Thank you!

1
Mithfu99•

With enough heat nothing is stuck 😈

0