r/volt•
Goodytwo3

Propulsion Power is Reduced and 3 Codes (P0123, P0223 & P2135)

Yikes! I have a 2015 Volt and got the propulsion power is reduced message along with the check engine light immediately coming on. The battery was almost full power and the car was under normal driving conditions, so I don't believe this to be a standard issue of PPR message that people get. Currently the car will start but essentially runs on gas only mode as far as I can tell and the idle is rough compared to the normal gas engine operation.

I had Onstar run an on demand diagnosis and all three codes are related to ECM and recommend service either immediately or within one day and the codes are (P0123, P0223 & P2135)

Still waiting for the dealership to call me back to even schedule and appointment. Does anyone have any advice on how I can get as much information as possible before I take the car in? Anyone familiar with these codes?

UPDATE: Dealer said it was a bad throttle body, quoted me $575 to fix and said it was not covered under the emissions warranty. Any one deal with a bad Throttle Body?

Posted Jul 23, 2021, 4:34 PM UTC · edited

319
techtornado2017 Volt•

Did you get the HPCM2 update to fix the battery balancing issue?

2
Goodytwo3OP•

I'm editing my response because I checked my Vin and it confirmed no additional recalls are available for this vehicle.

1
MK5RW3T•

Those are throttle position sensor codes. So your throttle body and accel pedal and wiring need to be checked out/ diagnosed

2
Goodytwo3OP•

This is wildly helpful. Unfortunately it sounds like something not covered under the voltec warraty. Am I right to assume that? Any idea if I should drive it to the dealership 10 miles away or have it towed?

2
MK5RW3T•

Unfortunately I think you may have to pay out of pocket for it. I would get it towed to a dealer but that's just me.

2
Goodytwo3OP•

Thanks for your advice. This is kind of a bummer as I know Dealerships charge out the wazoo to fix volts not under warranty. I'm not sure the 12v has ever been replaced, any chance that is acting up and causing these codes?

1
MK5RW3T•

P0123 is throttle position sensor 1 high voltage P0223 is throttle position sensor 2 high voltage P2125 is throttle position sensors 1-2 not plausible

You could have an open wire in the harness somewhere in the engine bay. Lots of possibilities

2