I’ve got a third drive (SSD) plugged in as well though. I was trying to clone the Lenovo hdd onto this new ssd, so I could put the ssd back into the laptop. Are you saying that the bottom two entries (D and E) are both one hard drive? I thought D was the new ssd.
It looks like there's a scroll bar on the bottom, try scrolling down, and that will show another drive, though, an easier way to do this would be a fresh Windows install (unless you have anything you absolutely need to keep, and even then, that can be backed up). But to answer your original question, anything inside a row is part of the same drive, so D: and E: are part of Disk 0, while C: and the EFI partition are Disk 1, now, how do you know what disk is what? Right click on a disk number, and then click "properties", that should shed some light on the situation.
That explains a lot, thank you so much. I did some poking around and found the mode number of the drive and i also confirmed that way that it is indeed the hard drive. It does look like, however, that my new ssd isn’t listed anywhere, even if I scroll down. I’ll try connecting it to another port or something, but if you’ve got any other suggestions, that would be much appreciated!
Also, about the whole other method of old ping this, I’ve already got everything set up to do it this way, and I didn’t wanna spend anymore money on anything lol, so looks like this is how I’m gonna be doing it :)
I would say definitely try an alternate port, you maaaay need to initialize a partition on the SSD? I doubt it, but that depends on your clone software.
If you look at the bottom, Disk 0 is the drive, LENOVO is just a 25 gig partition (presumably a recovery partition), D: is your windows partition.
I’ve got a third drive (SSD) plugged in as well though. I was trying to clone the Lenovo hdd onto this new ssd, so I could put the ssd back into the laptop. Are you saying that the bottom two entries (D and E) are both one hard drive? I thought D was the new ssd.
Thanks for the help btw!
It looks like there's a scroll bar on the bottom, try scrolling down, and that will show another drive, though, an easier way to do this would be a fresh Windows install (unless you have anything you absolutely need to keep, and even then, that can be backed up). But to answer your original question, anything inside a row is part of the same drive, so D: and E: are part of Disk 0, while C: and the EFI partition are Disk 1, now, how do you know what disk is what? Right click on a disk number, and then click "properties", that should shed some light on the situation.
That explains a lot, thank you so much. I did some poking around and found the mode number of the drive and i also confirmed that way that it is indeed the hard drive. It does look like, however, that my new ssd isn’t listed anywhere, even if I scroll down. I’ll try connecting it to another port or something, but if you’ve got any other suggestions, that would be much appreciated!
Also, about the whole other method of old ping this, I’ve already got everything set up to do it this way, and I didn’t wanna spend anymore money on anything lol, so looks like this is how I’m gonna be doing it :)
I would say definitely try an alternate port, you maaaay need to initialize a partition on the SSD? I doubt it, but that depends on your clone software.
Yes, D and E are two different partitions on the same drive.
This ⬆️